Specification: Condition: 100% Brand New Item Type: RC Car Shell Material: ABS Plastic Wheelbase: Approx. 313mm / 12.3in Total Length: Approx. 500mm / 19.7in Front Width: Approx. 200mm / 7.9in Rear Width: Approx.205mm / 8.1in Fitment: Fit for 1/10 RC Car /SCX10/SCX10 II 90046 90047 Assembly Instructions: 1. Use B2 screws and M3 nuts on both sides and side doors to tighten them from inside. 2. One B1 screw and two C1 screws are used on both sides of the car, and 2pcs 01 screws are used on the roof of the car. 3. Use 8pcs A1 screws to tighten the front guardrail on both sides of the wheel;The last one on both sides of the wheel front guardrail is fastened with an A2 screw;The rear guardrail on both sides of the wheel is fastened with 9pcs A1 screws. 4. The front guardrail is secured from the rear with 4pcs C2 screws.Install it to the front and fasten the inside with 2pcs D1 screws and C2 screws. 5. Two headlights are installed from the inside of the car shell and fastened with a C2 screw for each. 6. Two fog lamps are installed from outside to inside the car shell.Glue and fix from the inside. 7. Install windshield wipers, left and right rearview mirrors, left and right door handles, and rear door wipers. Install two heat dissipation holes,pay attention to the left and right directions. 8. To install the rear lamp, two A3 screws and M2 nuts should be used to install the rear guardrail from the outside to the inside, and the nuts should be fastened inside. Package List: 1 x Set of RC Car Shell 8 x Bag of Screw (Including 10pcs Nut) 1 x Sticker 1 x Manual